Quick question

Discussion pertaining to positive pressure E28s.
Post Reply
Andre2020
Posts: 46
Joined: Feb 12, 2006 12:00 PM
Location: Barnesville, GA

Post by Andre2020 »

Does TCD do the installing on the s1 and s2 systems or do they just provide the parts?
rundatrack
Posts: 454
Joined: Feb 12, 2006 12:00 PM

Post by rundatrack »

I think you would have to go to their headquarters to get the install...

But I have heard that if your a DIY type of person or have a mechanic ya use ...they should be fine...

So both...
gol10dr1
Posts: 394
Joined: Feb 12, 2006 12:00 PM
Location: boston (maryland during summer)

Post by gol10dr1 »

well todd and chris m. did my install but taht is because i am not handy in the least (!) and i was going to school in boston so dropping my car off at todd's house was almost on the way to school so it worked out perfectly (plus gave me a reason to keep the car up here in boston instead of take it home to the rents so dad could drive the piss out of it and not me!).
Bill in MN
Posts: 1718
Joined: Feb 12, 2006 12:00 PM
Location: The Boonies, Mn
Contact:

Post by Bill in MN »

I did my own and it was not that difficult. I have one of the first kits produced for the M30 and if I'm not mistaken there have been subtle changes to make things go even easier.

The only real issues I had were in getting the thing to run right but that was due to a bad harness in my car, not the kit. If a person does their homework and takes their time it is pretty straightforward. They provide good instructions and thier customer service is second to none.
Post Reply