a few pics of my good & tight manifold

[JesterMX6]

I started getting it ready to bolt on and i've been taking pics as i go.

September 7, 2014

I'm getting antsy. It's time to prep parts for install. Yesterday I started coating the exhaust manifold.


2014.09.07 coating the manifold by jestermx6, on Flickr


2014.09.07 coating the manifold 2 by jestermx6, on Flickr


2014.09.07 coating the manifold 3 by jestermx6, on Flickr

Once i get the coating cured, i've got some titanium exhaust wrap to cover the manifold. Gonna be tight between some of those runners though, so hopefully i don't have to many gaps in the wrap.

September 11, 2014

Started work on wrapping the manifold. This is a lot tougher than i thought it would be.


2014.09.11 wrapping the manifold by jestermx6, on Flickr

plastic zip ties will be replaced with stainless ones before i spray a coating over the wrap. the plastics are just there to help with the wrapping process and keep the winds tight.

[JesterMX6]

more!


2014.09.13 manifold installed by jestermx6, on Flickr


2014.09.13 wastegate installed by jestermx6, on Flickr

2014.09.13 turbo mock up by jestermx6, on Flickr

[ZenitramNaes]

Dude, looking good! I've got a good N tight manifold lined up, hopefully it will be mine soon enough.

[Good & Tight]

Looking good..!!!

[528KC]

Where do you find said Good&Tight manifolds? And what's about did it cost ya? If you don't mind me asking.

Edit: Do you maybe get them from ^^that guy^^?

[TheGraye28]

What Turbo? HX40?

[JesterMX6]

H1E, which i think is similar. just older.

[TheGraye28]

And wastegate has to be a 44
Mm vband right? Kinda screws up my plans to use a synapse

[JesterMX6]

yes it's 44mm vband. can always run an adapter in between, but you may run into clearance issues.