separate emu?

cwl4m5 · Post by **cwl4m5** » May 19, 2006 9:09 PM

I am having problems with getting a separate emu to work on 1988 535is turbo I tried tec 3 had problems with it the last one was we could not get a signal fron trigger wheel sensor we have tried several sensors to no avail have now switched to megasquirt and running into same problen canot figure out why getting no trigger wheel reading we have tried everything any suggestions

Post by **Jeremy** » May 19, 2006 9:25 PM

What are you trying to use for a trigger wheel?

Joe in FL · Post by **Joe in FL** » May 20, 2006 1:17 PM

Mark 88/M5 Houston · Post by **Mark 88/M5 Houston** » May 20, 2006 1:29 PM

Possibly a bad wiring harness?

cwl4m5 · Post by **cwl4m5** » May 20, 2006 1:34 PM

trigger wheel is off e34 I think, its not the wiring harness two totally different wiring put in place but same problem. we believe its is electrical noise

Skeen · Post by **Skeen** » May 21, 2006 12:39 AM

What version of MS are you using?

Velocewest · Post by **Velocewest** » May 21, 2006 2:41 AM

Joe in FL wrote:

Same thing that crossed my mind...

cwl4m5 · Post by **cwl4m5** » May 21, 2006 12:25 PM

what ever the latest version is

russc · Post by **russc** » May 22, 2006 2:44 PM

If you think it is noise, you'll need a oscope to see how much noise is on pwr and gnd signal. If there is alot of noise, you'll need to make better pwr and gnd connections.

Make sure you chech continuity on the sensor signals, and check their ohmage carefully. You also may have a faulty sensor. It should read some specific ohmage, you'll need a Bentley manual to get that spec.

RussC

cwl4m5 · Post by **cwl4m5** » Jun 04, 2006 12:14 AM

they resoldered something and it started right up

bahnstormer · Post by **bahnstormer** » Jun 05, 2006 9:15 AM

they?

bad comp board?

pics?

any more info?

cwl4m5 · Post by **cwl4m5** » Jun 05, 2006 3:59 PM

megasquirt

MyE28.com

MyE28.com

separate emu?

separate emu?

it was a bad comp board