Bcoronado1 wrote: As always I'm trying to prove that we can turbo these cars for relatively inexpensive
This makes me laugh. People have been bolting cheap junk onto these motors long before everyone started a "build thread" to prove how smart/ingenious they are.
Bcoronado1 wrote: As always I'm trying to prove that we can turbo these cars for relatively inexpensive
This makes me laugh. People have been bolting cheap junk onto these motors long before everyone started a "build thread" to prove how smart/ingenious they are.
Good luck with the build.
Not saying i'm ingenious, just a college kid with barely enough money for a decent project.
It's a T4 drilled for a T3 flange also.
I don't think that WG comes with the manifold, would have to check the description, but the one I bought last fall (ish) didn't come with one.
Well if it doesn't come with the wastegate the $50 discount is not worth it.
With G&T at least you have support if it cracks. but through ping ling on ebay you have non.
Well if it doesn't come with the wastegate the $50 discount is not worth it.
With G&T at least you have support if it cracks. but through ping ling on ebay you have non.
Really the $50 isnt't worth it because you wait for the part to be shipped from germany i think too, so it takes several weeks to receive, it's just nice to have both flanges.. From Ottis my manifold was on my door step within the week.
Update: A few parts are waiting on powder coating. So i'm trying to tackle MS2 Extra, but I can't get Tuner studio to recognize 3.3.1 may be a problem with the COM to USB adapter i bought, or a firmware issue (If anyone has had this problem please chime in.) Also if anyone has a stock base tune I would appreciate it.
You did load the usb adapter driver right? Sorry if thats a stupid question. When I did megasquirt the laptop interface settings were my weakest link.
good luck!
marc79euro645 wrote:You did load the usb adapter driver right? Sorry if thats a stupid question. When I did megasquirt the laptop interface settings were my weakest link.
good luck!
Took me a while to figure out how to installed the one from diyautotune finally figured it out about 2am this morning. Had to make my USB port a COM3 port also. (along with a new driver) For me this was the most confusing part of the build yet. I think I have t handled now though.
