I'm about ready to install an intercooler into my 524td. (Don't laugh!!!) Since it's a turbo diesel that generally run higher boost pressures than gassers, I'm concerned about blowing apart the IC piping connections. My boost pressure target is somewhere around 20psi.
Is there any sealant or adhesive that you would recommend to prevent this?
Well, the first pass at this is done. Also, thanks for the hairspray idea. I'll need to take some of this apart to adjust the fueling and timing so I'll use that when I re-assemble it. I tried to insert a pic of my IC install, but it might not be allowed being that you need to be a part of the 524td group.