Megasquirt Users

[Maddog]

For all of you megasquirt users on the forum, what is your AFR at idle? I am trying to get an idea of what kind of good results other people are getting. I am running about 13.5:1 with 12 degrees of advance and my engine is very happy. I am curious to see if anyone has been able to get their engine to idle at 14.7 without the engine "hunting" at idle.

[T_C_D]

For all of you megasquirt users on the forum, what is your AFR at idle? I am trying to get an idea of what kind of good results other people are getting. I am running about 13.5:1 with 12 degrees of advance and my engine is very happy. I am curious to see if anyone has been able to get their engine to idle at 14.7 without the engine "hunting" at idle.

We run 14 degrees at idle.

These motors typically do not like 14.7 at idle. I tune idle for smoothness not economy. 900rpm and high 13s do it for me.

[FirstFives Dictator]

For all of you megasquirt users on the forum, what is your AFR at idle? I am trying to get an idea of what kind of good results other people are getting. I am running about 13.5:1 with 12 degrees of advance and my engine is very happy. I am curious to see if anyone has been able to get their engine to idle at 14.7 without the engine "hunting" at idle.

That sounds good; it's all about making the motor 'happy'.
My worn-out m30 idles at about 35KPA warm.
Is yours similar?

[Maddog]

I have been idling around 40kpa. This was a bit higher than I wanted, but I haven't been able to get it lower.

[Maddog]

That sounds good; it's all about making the motor 'happy'.
My worn-out m30 idles at about 35KPA warm.
Is yours similar?

What RPM are you idling at and what advance are you running to be able to run at 35kpa?

[rs4pro3]

my m20 either idles at around 12-13 at a low rpm real ruff idle, or 15-16 at a 1300 rpm idle

[FirstFives Dictator]

That sounds good; it's all about making the motor 'happy'.
My worn-out m30 idles at about 35KPA warm.
Is yours similar?

What RPM are you idling at and what advance are you running to be able to run at 35kpa?

14 degrees and 900-950

It's an e12 so I'm used to a little higher idle and no idle control

[OldgreenE34]

I just got my car to pass Ontario Emissions with:

12 degrees advance
14.8:1 target and 3% authority to the wideband closed loop
47 KPa
1000 RPM
measured mixture - from 14.9 to 15.2

Emissions measured

CO% = 0.00
HC ppm = 10

the car idles like a stock E34 535 in terms of solid and smooth.

Dave

[Brad D.]

OldgreenE34, are you using MS now or are you still using the Perfect Power SMT?

[OldgreenE34]

MS on the TCD 1988 M6
SMT-6 on the TCD 1990 535

Dave