MyE28.com

Y'all

For the foreseeable future, I'm going to be installing my "new" M30B35 with my "old" M30B34 Motronic. Since the new engine doesn't have the intake manifold support brackets on top, I need a place to attach the flywheel sensor connectors. The bracket on the upper firewall cover in this pic from Scottie Sharpe's site would seem to fill the bill, as I think my current wiring harness and sensors have sufficient length:



What's the P/N on that bracket, and is it still available?

TIA,
Shawn


[Edit by Shawn D. on [TIME]1109704500[/TIME]]

[QUOTE="Shawn D."]Y'all

For the foreseeable future, I'm going to be installing my "new" M30B35 with my "old" M30B34 Motronic. Since the new engine doesn't have the intake manifold support brackets on top, I need a place to attach the flywheel sensor connectors. The bracket on the upper firewall cover in this pic from Scottie Sharpe's site would seem to fill the bill, as I think my current wiring harness and sensors have sufficient length:



What's the P/N on that bracket, and is it still available?

TIA,
Shawn

[Edit by Shawn D. on [TIME]1109704500[/TIME]][/QUOTE]
12 14 1 308 548 is the one listed on the ETK as the bracket for the pulse generator for the 88 M5, but the illustration dosent look quite the same as that one.