Page 1 of 1
MS2PNP adapter board
Posted: Nov 13, 2016 9:12 PM
by Nebraska_e28
I just finished building a MS2PNP board, but am not finding the instructions how to connect the jumpers to the Bosch 55pin adapter board. Maybe it's on the DIY site but overlooked it. Thought I'd post here first for assist. TIA!
Re: MS2PNP adapter board
Posted: Nov 14, 2016 7:51 AM
by Cjames570
There is a 55-pin pinout in the megaquirt faq that should be able to get you on the right track. just match the ms signal with the correct 55-pin pin
Re: MS2PNP adapter board
Posted: Nov 17, 2016 1:02 PM
by Nebraska_e28
From what I saw it shows where most of the jumpers go, but there are a few left out of the diagram.