Page 1 of 1
Posted: Nov 27, 2005 8:18 AM
by DMNaskale
I picked up one of these manifolds on eBay:
I am going to graft two M30 engines together end to end, get a custom billet steel crank and camshaft made, do some modifications to my car to make it fit, and build the ultimate turbo E28.
Does anyone know of a good source for a turbo that would work on this application?
Posted: Nov 27, 2005 8:29 AM
by robeyff
I am going to graft two M30 engines together end to end,
How are you going to do that? Where are you going to sit?
Posted: Nov 27, 2005 9:26 AM
by DMNaskale
How are you going to do that?
JB Weld and duct tape.
Where are you going to sit?
In the back seat.
Posted: Nov 27, 2005 9:29 AM
by Skeen
I believe you could use this turbo:
Posted: Nov 27, 2005 9:37 AM
by Boru
I think you should make it into a boxer engine. Use one stock crank, mill the connecting rods down so two of them will fit on one crank journal and just bolt the two blocks together at the oil pan mounting surfaces... simple.
Posted: Nov 27, 2005 10:34 AM
by DMNaskale
I think you should make it into a boxer engine...... just bolt the two blocks together at the oil pan mounting surfaces... simple.
I tried that once, but I couldn't figure out how to change the oil.
[Edit by DMNaskale on [TIME]1133105731[/TIME]]
Posted: Nov 27, 2005 10:46 AM
by robeyff
How are you going to do that? Where are you going to sit?
Reel 'im in boys, he's a biggun! I'm going to go out to the garage now and
write "think before you ask" a couple hundred times on the wall above
my left handed shelf stretcher. (@)
Posted: Nov 27, 2005 12:47 PM
by Yellow2
Bolt one of these into your car. If you wanan laugh, go down to the videos and see what they are using it for.
SUPER TURBO !!!!!!!
[Edit by Yellow on [TIME]1133113693[/TIME]]
Posted: Nov 27, 2005 1:34 PM
by Jeremy
[QUOTE="Yellow"]Bolt one of these into your car. If you wanan laugh, go down to the videos and see what they are using it for.
SUPER TURBO !!!!!!! [/QUOTE]
That is the best ghetto rigged jet turbine with afterburner that I have EVER seen! Watch the night afterburner video, the thing looks like it's about to melt the welds and fly apart!! Sweet.
Jeremy
Posted: Nov 27, 2005 1:50 PM
by Yellow2
No kidding. You can see where it penetrated the welds at the end of the thrust tube part and is leaking. GOod stuff.
Posted: Nov 27, 2005 2:37 PM
by BDK
Don't laugh, I remember when the Wankel (sp) guys started talking about grafting
two rotary motors together, eventhough it was an easier task since the rotary motors
are put together like a loaf of bread and they were just adding more slices if you will....
I think the V12 is based on Daryl ideas eventhough they are not mounted end to end
but side to side....