MyE28.com

I was wondering the specs on the bolts that hold the wastegate to the Manifold.

I just drilled my oil pan, should be tapping it in a little bit, hoping to start it for the first time tommorow or next day(with no exhaust YET).

Thanks!

90e34535i wrote:I was wondering the specs on the bolts that hold the wastegate to the Manifold.

I just drilled my oil pan, should be tapping it in a little bit, hoping to start it for the first time tommorow or next day(with no exhaust YET).

Thanks!

5/16 - 18

Thanks Todd,

I got a tottally different question,

Are you using the stock Coolant Temp Sensor with your MS System?
I noticed my Coolant temp sensor has 3 wires, would you happen to know which of those I use?

thanks again,

90e34535i wrote:Thanks Todd,

I got a tottally different question,

Are you using the stock Coolant Temp Sensor with your MS System?
I noticed my Coolant temp sensor has 3 wires, would you happen to know which of those I use?

thanks again,

Hu,
You sure. If your sig is right, any '90 M30b35 has a two wire temp sensor. Its the same sensor as the M30b34!

RussC

Maybe im looking at a level sensor? Its screwed into the top of the radiator on the passenger side, Where should I be looking?

90e34535i wrote:Maybe im looking at a level sensor? Its screwed into the top of the radiator on the passenger side, Where should I be looking?

That's not the coolant temp sensor -- that's an aux fan switch, and it's on the cold side of the radiator to boot. The coolant temp sensor is on the thermostat housing.

Alright, definitly makes sence, thanks alot!