Yikes! Tubular Intake Manifold.
Posted: Jun 12, 2007 8:08 PM
Did anyone see this? It breaks every rule of manifold design. M30 Tubular Intake Manifold
Page 1 of 1
Posted: Jun 12, 2007 8:30 PM
Wow, a 4 barrel intake with the flow characteristics of a 1 barrel Solex manifold....awesome!!!
Posted: Jun 12, 2007 9:05 PM
Holy crap 
Posted: Jun 12, 2007 9:07 PM
board member, right?
Posted: Jun 12, 2007 9:22 PM
Board member indeed. Neat item also, but... Nah.
Posted: Jun 12, 2007 9:52 PM
Wow, such even distribution out of water pipe.
Vance
Vance
Posted: Jun 12, 2007 10:33 PM
Man, if that was $15 total, I'd bid on it. Just to have it.
I think we could turn that into the "best beater" trophy at 5er fest and hand it down from year to year, kinda like the "best breakdown" trophy.
After all, it probably just barely works, and is ugly as all get out.
I think we could turn that into the "best beater" trophy at 5er fest and hand it down from year to year, kinda like the "best breakdown" trophy.
After all, it probably just barely works, and is ugly as all get out.
Posted: Jun 12, 2007 10:39 PM
I think that manifold is the cousin to the "tunnel ram" a guy at my high school made for his primer-red '71 Nova: it consisted of two carb baseplates, carb-body-side facing together at the ends of four 2-foot tubes. One baseplate bolted on the intake manifold in the normal carb position and then the carb bolted to the other baseplate, outside the hood. 