WTB 535/533/733 driveshaft + m30b34 motor mounts.

Buy, sell, or trade parts.
Post Reply
willis
Posts: 171
Joined: Mar 25, 2012 8:29 PM
Location: Bend Oregon

WTB 535/533/733 driveshaft + m30b34 motor mounts.

Post by willis »

I'm swapping an m30 from an e23 733, into my 528e.

I thought I could swap over the output shafts from my m20 getrag to my m30 getrag.(I can't ever keep the numbers straight), but I read somewhere the splines won't work, so I'm just going to use the base of an m30 driveshaft and the back of my m20 driveshaft. I've heard that will work?

You can see the different sizes here.
Image

If anyone has one PM me.

In addition I was told the 733 mounts will work but in fact they do not line up. So I need 535/533 mounts.

Yeah so I need those things. PM me!

Picture of said m30 in said e28
Image
(I know my maf is backward)
ahab
Posts: 6201
Joined: Jun 11, 2006 9:12 AM
Location: Chalfont, PA

Post by ahab »

Whatchu talkin 'bout Willis?
fastcrs
Posts: 660
Joined: Jan 25, 2011 10:53 PM
Location: Nor Cal

Post by fastcrs »

Clean engine bay would be a understatement...great job..
willis
Posts: 171
Joined: Mar 25, 2012 8:29 PM
Location: Bend Oregon

Post by willis »

No no no I need those parts not compliments and tv quotes. Doesn't even run!

Thanks :)
1st 5er
Posts: 21865
Joined: Jun 13, 2008 12:15 AM
Location: Cypress
Contact:

Post by 1st 5er »

If you need the front half of an M30 driveshaft and
a set of 535/533 supporting brackets (motor mounts are the rubber parts that go between the brackets and the front axle support, 'cross member'),
send me an offer shipped from 77429?
Post Reply